Introducing the GTS / GTS-T / GTT / GT25 / GTS-4 / Solution - Created because we all deserve a cool emblem. Something about a SKYLINE with that cool badge. Let's face it, the GTR badge really has always been that cherry on top when it comes to aesthetics. It's absence often times leave the cars looking naked.
What we've done here isn't to copy, pretend or knock-off the GTR but be something that pays homage with its own uniqueness. It had to look like a "Nissan" and considering its from Japan, let's do something we haven't seen anyone done before. Kanji writing スポーツ which translates to "SPORT" in English below. We know.. it may seem redundant but not everyone reads Japanese, yet it's still going to be a conversation starter whenever pulling up at a car meet.
Installation: FRONT
Comes with two M4 Bolt studs out the back with vertical spacing of 30 mm, 4 rubber washers to sandwich the grille mesh followed by a stainless-steel waster for even pressure after securing with locking nylon nuts. (Do not over tighten! Should only be a snug) -- All Mentioned Hardware included.
It does not require this specific way of installing, but this is just the most universal options for all the different variation of grilles, mesh, etc on the market.
No Grille Mesh? No problem
Could even be mounted with a DIY "L" bracket with double sided 3m adhesive at the bottom of the bracket mounted directly to bumper or grille with no mesh and 2 holes 30 mm apart to accept the M4 bolt studs on the emblem.
Installation: BACK
😁 Simply peel and stick to your rear trunk lid (be sure to clean the surface prior to installed, a good wash and properly DRY area is suitable. Though it's a double-sided 3M tape, it takes up to 24 hours for the bond to your vehicle to be optimum, so keep it dry, stick it and leave it. Don't worry, once you stick it, you can drive your car around no problem without it falling off or anything of that nature.
What we've done here isn't to copy, pretend or knock-off the GTR but be something that pays homage with its own uniqueness. It had to look like a "Nissan" and considering its from Japan, let's do something we haven't seen anyone done before. Kanji writing スポーツ which translates to "SPORT" in English below. We know.. it may seem redundant but not everyone reads Japanese, yet it's still going to be a conversation starter whenever pulling up at a car meet.
Installation: FRONT
Comes with two M4 Bolt studs out the back with vertical spacing of 30 mm, 4 rubber washers to sandwich the grille mesh followed by a stainless-steel waster for even pressure after securing with locking nylon nuts. (Do not over tighten! Should only be a snug) -- All Mentioned Hardware included.
It does not require this specific way of installing, but this is just the most universal options for all the different variation of grilles, mesh, etc on the market.
No Grille Mesh? No problem
Could even be mounted with a DIY "L" bracket with double sided 3m adhesive at the bottom of the bracket mounted directly to bumper or grille with no mesh and 2 holes 30 mm apart to accept the M4 bolt studs on the emblem.
Installation: BACK
😁 Simply peel and stick to your rear trunk lid (be sure to clean the surface prior to installed, a good wash and properly DRY area is suitable. Though it's a double-sided 3M tape, it takes up to 24 hours for the bond to your vehicle to be optimum, so keep it dry, stick it and leave it. Don't worry, once you stick it, you can drive your car around no problem without it falling off or anything of that nature.